Resolver Configuration
Posted by Matthew Jeffels, Last modified by Matthew Jeffels on 12 September 2016 03:16 PM

Resolver Configuration

The resolver configuration section allows you to change the /etc/resolv.conf file. This is the file that contains the nameservers that your server will use to query domain names into IP addresses.

Resolver Configuration

Clicking on proceed will take you to the next interface;

Resolver Configuration Options

From here you can enter two or three resolver addresses for your server to use. Your server needs to have at least two addresses to function however the third address is optional.

NOTE; you can only use IPv4 addresses as the resolvers. The server will not recognise IPv6 address. In addition if you do not configure the resolvers correctly, your server will not connect to the Internet.

To complete the configuration click continue.

If successful you should be presented with a screen that looks somewhat like this;

Reference Config Success

Thanks

Matt Jeffels
PAC Web Hosting

(0 vote(s))
Helpful
Not helpful

Comments (0)